Advanced Active Filter AAF with Reduced DC Link Voltage IJTSRD


In recent years voltage and current harmonics are become serious problem in transmission and distribution system. To eliminate these voltage and current harmonics and to achieve clean grids, AAF are been used. The existing AAF technology requires a higher dc link voltage to achieve the THD requirement therefore this paper presents an Advanced Active Filter AAF for IGBT and LCL network in order to maintain voltage balance among dc link. This method is well capable of balancing charging and discharging of dc link voltage without increasing circuit complexity. This modulation technique is very effective in terms of voltage balancing as well as for maintaining voltage output THD at low level. The proposed system is implemented in Simulink platform of MATLAB software and performance shows its effectiveness over conventional IGBT used for inverter

by Tamil Selvan P | Vinothkumar K | Sugumar V “Advanced Active Filter (AAF) with Reduced DC Link Voltage” Published in International Journal of Trend in Scientific Research and Development (ijtsrd), ISSN: 2456-6470, Volume-3 | Issue-3 , April 2019,

URL: https://www.ijtsrd.com/papers/ijtsrd21764.pdf

Paper URL: https://www.ijtsrd.com/engineering/electronics-and-communication-engineering/21764/advanced-active-filter-aaf-with-reduced-dc-link-voltage/tamil-selvan-p

call for paper Civil Engineering, international journal Agricultural Engineering, ugc approved journals for engineering




Advanced Active Filter AAF with Reduced DC Link Voltage IJTSRD IEEE PAPER





2020 technology trends
2019-TOP-TECHNOLOGIES
2019 papers
2018-TOP-TECHNOLOGIES
2018 papers

IEEE PROJECTS 2019


IEEE PROJECTS CSE 2019
IEEE PROJECTS ECE 2019
IEEE PROJECTS EEE 2019
IEEE PROJECTS VLSI
IEEE PROJECTS EMBEDDED SYSTEM

IEEE PROJECTS


IEEE PROJECTS ECE
IEEE PROJECTS CSE COMPUTER SCIENCE
IEEE PROJECTS ELECTRICAL ENGINEERING
IEEE PROJECTS EEE

IEEE PROJECTS