Design and Developing of Two Wheeler Handle Gripper Using 3D Printing Technology IJTSRD


This paper provides information about design and developing of two wheeler handle gripper using the 3D printing. This technology allows to build a part in such a wat that thermoplastic material through nozzle deposited layer by layer and manufacture with high degree of freedom unachievable with the traditional manufacturing method. These two wheeler handle grippers TWHG play important role in providing grip to driver during vehicle running and idle conditions, it is difficult to make firm grip between hand and handle without handle gripper on two wheeler handle. For this paper purpose handle gripper model is created in CATIA V5, it is fully three dimensional modelling software, by using this model of handle grippers 3D printed handle grippers are created by the method of fused deposition process of rapid prototyping technology.

by S. Suresh | Duppelly Vamshi | Boda Rahul | Dharavath Ashok Kumar “Design and Developing of Two-Wheeler Handle Gripper Using 3D Printing Technology”

Published in International Journal of Trend in Scientific Research and Development (ijtsrd), ISSN: 2456-6470, Volume-3 | Issue-3 , April 2019,

URL: https://www.ijtsrd.com/papers/ijtsrd23311.pdf

Paper URL: https://www.ijtsrd.com/engineering/mechanical-engineering/23311/design-and-developing-of-two-wheeler-handle-gripper-using-3d-printing-technology/s-suresh

call for paper Bio system Engineering, international journal Environment Engineering, ugc approved journals for engineering




Design and Developing of Two Wheeler Handle Gripper Using 3D Printing Technology IJTSRD IEEE PAPER





2020 technology trends
2019-TOP-TECHNOLOGIES
2019 papers
2018-TOP-TECHNOLOGIES
2018 papers

IEEE PROJECTS 2019


IEEE PROJECTS CSE 2019
IEEE PROJECTS ECE 2019
IEEE PROJECTS EEE 2019
IEEE PROJECTS VLSI
IEEE PROJECTS EMBEDDED SYSTEM

IEEE PROJECTS


IEEE PROJECTS ECE
IEEE PROJECTS CSE COMPUTER SCIENCE
IEEE PROJECTS ELECTRICAL ENGINEERING
IEEE PROJECTS EEE

IEEE PROJECTS