Design and Modeling of Pull Rod and Push Rod Suspension System IJTSRD
The main criterion of this project is to design a suspension system practically to a student formula vehicle and for systems, now loads are distributed to front and rear side. The stiffness of the spring is calculated by considering front and rear loads. The design of the spring, dash pot, rocker arms and push rod were done by LOTUS SHARK and modelling of these is done in SOLIDWORKS software. Later, the assembly of all parts and mono spring rocker arm front suspension system were designed racing cars. The dynamic loads are to be considered for the design of wheel assembly, frame, and transmission, steering and braking.
by Sateesh Kumar Revoor | Mittapally Nikhil | Jatothu Sucharitha | D. Anil “Design and Modeling of Pull Rod & Push Rod Suspension System”
Published in International Journal of Trend in Scientific Research and Development (ijtsrd), ISSN: 2456-6470, Volume-3 | Issue-3 , April 2019,
URL: https://www.ijtsrd.com/papers/ijtsrd23263.pdf
call for paper Petroleum Engineering, international journal Forestry Engineering, ugc approved journals for engineering