Optimization of EDM Process Parameters using Response Surface Methodology for AISI D3 Steel IJTSRD



The present work demonstrates the optimization process of material removal rate MRR of electrical discharge machining EDM by RSM Response Surface Methodology . The work piece material was EN31 tool steel. The pulse on time, pulse off time, pulse current and voltage were the control parameters of EDM. RSM method was used to design the experiment using rotatable central composite design as this is the most widely used experimental design for modeling a secondorder response surface. The process has been successfully modeled using response surface methodology RSM and model adequacy checking is also carried out using Minitab software. The second order response models have been validated with analysis of variance. Finally, an attempt has been made to estimate the optimum machining conditions to produce the best possible responses within the experimental constraints.

BY Dr. N. Mahesh Kumar | Mr. P. Chinna Rao “Optimization of EDM Process Parameters using Response Surface Methodology for AISI D3 Steel”

Published in International Journal of Trend in Scientific Research and Development (ijtsrd), ISSN: 2456-6470, Volume-3 | Issue-3 , April 2019,

URL: https://www.ijtsrd.com/papers/ijtsrd23535.pdf

Paper URL: https://www.ijtsrd.com/engineering/mechanical-engineering/23535/optimization-of-edm-process-parameters-using-response-surface-methodology-for-aisi-d3-steel/dr-n-mahesh-kumar

call for paper Industrial Engineering, international journal Software Engineering, ugc approved journals for engineering