Study of the Effects of Process Parameters on Tool Wear Rate in Electrical Discharge Machining by Taguchi Method ijtsrd


EDM machines are used to cut conductive metals of any hardness or that are difficult or impossible to cut with traditional methods. The problem of arriving at the optimum levels of the operating parameters has attracted the attention of the researchers and practicing engineers for a very long time. This paper introduces the research results of tool wear rate of SKD11 steel after EDM. The influence of the process paramaters to the surface roughness Ra is surveyed and the optimal value Ra Ratoiuu also be established. The process parameters current I , pusle on time ton , pulse off time tof and voltage is used in research on SR in EDM. Taguchi method is used in this study.

by Minh – Nguyen Duc | Tai – Bui Tien “”Study of the Effects of Process Parameters on Tool Wear Rate in Electrical Discharge Machining by Taguchi Method””

Published in International Journal of Trend in Scientific Research and Development (ijtsrd), ISSN: 2456-6470, Volume-3 | Issue-6 , October 2019,

URL: https://www.ijtsrd.com/papers/ijtsrd29266.pdf

Paper URL: https://www.ijtsrd.com/engineering/mechanical-engineering/29266/study-of-the-effects-of-process-parameters-on-tool-wear-rate-in-electrical-discharge-machining-by-taguchi-method/minh—nguyen-duc

call for paper Gas Engineering, international journal Software Engineering, ugc approved journals Parallel Computing




Study of the Effects of Process Parameters on Tool Wear Rate in Electrical Discharge Machining by Taguchi Method ijtsrd IEEE PAPER





2020 technology trends
2019-TOP-TECHNOLOGIES
2019 papers
2018-TOP-TECHNOLOGIES
2018 papers

IEEE PROJECTS 2019


IEEE PROJECTS CSE 2019
IEEE PROJECTS ECE 2019
IEEE PROJECTS EEE 2019
IEEE PROJECTS VLSI
IEEE PROJECTS EMBEDDED SYSTEM

IEEE PROJECTS


IEEE PROJECTS ECE
IEEE PROJECTS CSE COMPUTER SCIENCE
IEEE PROJECTS ELECTRICAL ENGINEERING
IEEE PROJECTS EEE

IEEE PROJECTS