Comparative Analysis of Destructive and Non-Destructive Testing Method of Concrete Strength using Compressive and Rebound Harmmer Testing Method


This work presents a study on the comparison between Destructive Compressive test and Non destructive testing techniques Schmidt Rebound Hammer . Tests moisture content, Sieve analysis, particle density for aggregate and cement paste, bulk density, standard consistency of cement, slump test were performed on both the aggregate and cement to compare their accuracy of both methods and test the quality of the material to be used for concrete casting and estimating the strength of concrete. Seventy samples cubes of 150 x 150 x 150mm were prepared using mix designs of 1 2 4 with a constant w c ratio of 0.45 and were tested at 7, 14, 21 and 28 days respectively. From the results, the rebound number increased from an average of 12 for 7days to an average rebound number of 17.7 for 28days which is similar to the increment in compressive strength from an average of 24.3 for 7days to an average of 32 for 28days which show that the increment in the strength is uniform but 5 difference in value obtained. The slump test was between 62 78mm. From the results of the analysis, it was observed that the strength obtained from destructive process conformed to targeted mix value, whereas that of the Rebound hammer was below these values. Statistical analysis of the results obtained showed that 5 difference exists between the results obtained from the two methods. Hence, there was no significant difference between the means of the two methods for both mixes at a 0.05 level of significance. Non destructive Testing is observed to be more economical as it required no electricity and can also be used directly in the field.

by Onyeka, F. C | Mama, B. O “Comparative Analysis of Destructive and Non-Destructive Testing Method of Concrete Strength using Compressive and Rebound Harmmer Testing Method”

Published in International Journal of Trend in Scientific Research and Development (ijtsrd), ISSN: 2456-6470, Volume-4 | Issue-1 , December 2019,

URL: https://www.ijtsrd.com/papers/ijtsrd29389.pdf

Paper URL: https://www.ijtsrd.com/engineering/civil-engineering/29389/comparative-analysis-of-destructive-and-non-destructive-testing-method-of-concrete-strength-using-compressive-and-rebound-harmmer-testing-method/onyeka-f-c

international journals in engineering, call for paper social science, paper publication in science




Comparative Analysis of Destructive and Non-Destructive Testing Method of Concrete Strength using Compressive and Rebound Harmmer Testing Method





2020 technology trends
2019-TOP-TECHNOLOGIES
2019 papers
2018-TOP-TECHNOLOGIES
2018 papers

IEEE PROJECTS 2020


IEEE-PROJECTS-ON-CSE-2020
IEEE-PROJECTS-FOR-EEE-2020
IEEE-PROJECTS-FOR-ECE-2020
IEEE PROJECTS CSE 2019
IEEE PROJECTS ECE 2019
IEEE PROJECTS EEE 2019
IEEE PROJECTS VLSI
IEEE PROJECTS EMBEDDED SYSTEM

IEEE PROJECTS


IEEE PROJECTS ECE
IEEE PROJECTS CSE COMPUTER SCIENCE
IEEE PROJECTS ELECTRICAL ENGINEERING
IEEE PROJECTS EEE

IEEE PROJECTS