Design and Fabrication of Runner Blades of Cross Flow Turbine ijtsrd


This paper describes the design and fabrication of runner blades for cross flow turbine is presented. In this paper, the cross flow turbine’s runner is designed to produce 100 W electric powers from head of 4 m and the flow rate of 0.004 m ^3 s. For the given capacity and head of the turbine, the dimensions of runner diameter and width 265 mm and 132 mm is obtained respectively. The detail design calculation of the runner is described in this thesis. It is applicable to wide range of flow rate adjusting the runner length. The term hydropower refers to shaft power generated by converting potential and kinetic energy of power. By using water power, the generation of electrical power is well known and widely used throughout the world. In hydropower plant, water turbine is one of the most important parts for generating electricity. This paper is to fulfill the required electricity in rural area.

by Ma Thu Zar Win | Ma Myat Win Khaing | Ma Yi Yi Khin “Design and Fabrication of Runner Blades of Cross-Flow Turbine”

Published in International Journal of Trend in Scientific Research and Development (ijtsrd), ISSN: 2456-6470, Volume-3 | Issue-5 , August 2019,

URL: https://www.ijtsrd.com/papers/ijtsrd27990.pdf

Paper URL: https://www.ijtsrd.com/engineering/mechanical-engineering/27990/design-and-fabrication-of-runner-blades-of-cross-flow-turbine/ma-thu-zar-win

call for paper Artificial Intelligence, international journal Computer Hardware, ugc approved journals Environment Engineering




Design and Fabrication of Runner Blades of Cross Flow Turbine ijtsrd IEEE PAPER





2020 technology trends
2019-TOP-TECHNOLOGIES
2019 papers
2018-TOP-TECHNOLOGIES
2018 papers

IEEE PROJECTS 2019


IEEE PROJECTS CSE 2019
IEEE PROJECTS ECE 2019
IEEE PROJECTS EEE 2019
IEEE PROJECTS VLSI
IEEE PROJECTS EMBEDDED SYSTEM

IEEE PROJECTS


IEEE PROJECTS ECE
IEEE PROJECTS CSE COMPUTER SCIENCE
IEEE PROJECTS ELECTRICAL ENGINEERING
IEEE PROJECTS EEE

IEEE PROJECTS