Design and Implementation of Automatic Fire Fighting for Building using Peripheral Interface Controller ijtsrd
In this project, we have designed and implemented automatic fire fighting for building using PIC. It intended to prevent accidents and emergency cases of fire. It consists of gas sensor for detecting the fire, temperature sensor for sensing the environmental temperature, relay driver for pump control, alarm system and fire extinguishing system. When the temperature sensor detects a predefined temperature, the LED and buzzer will be turn on. When the smoke detector gas sensor senses a certain amount of smoke, the LED and buzzer will turn on. If both the temperature and smoke reach a predefined level, the alarm will ring and the extinguishing system will also activate, too. The advantage of this project is to reduce the amount of damages done by fire. The weak point of this project is the power supply using AC, so it will not work when electricity is out.
by Tin Tin Ohn | May Thet Htar | Pyae Phyo Swe “Design and Implementation of Automatic Fire-Fighting for Building using Peripheral Interface Controller”
Published in International Journal of Trend in Scientific Research and Development (ijtsrd), ISSN: 2456-6470, Volume-3 | Issue-5 , August 2019,
Design and Implementation of Automatic Fire Fighting for Building using Peripheral Interface Controller ijtsrd IEEE PAPER
Design and Performance Analysis of Power Factor Controller ijtsrd
Brain Tumor Detection System for MRI Image ijtsrd