Optimization of Dry End Milling Process Parameters of Al-6063 Alloy Using Taguchi Method IJTSRD


This paper presents on optimizing the end milling process parameters based on the Taguchi method to minimize surface roughness and Tool wear for the work piece of Al-6063 alloy with high speed steel. The input parameters are speed (rpm), feed rate (mm/min) and depth of cut (mm). S/N ratio is calculated by using Taguchi method under the L9 orthogonal array (OA) with 3 factor and 3 levels. This S/N ratio is analysed by analysis of variance (ANOVA),and also find out the effects of control factor with help of analysis of variance. Finally, Results shown that, Taguchi design is the significant method to optimizing the milling process parameters of Speed 1200 rpm with 20% Significant.

by Arun K K | Ponnuswamy D”Optimization of Dry End Milling Process Parameters of Al-6063 Alloy Using Taguchi Method”

Published in International Journal of Trend in Scientific Research and Development (ijtsrd), ISSN: 2456-6470, Volume-2 | Issue-3 , April 2018,

URL: http://www.ijtsrd.com/papers/ijtsrd11643.pdf

http://www.ijtsrd.com/engineering/mechanical-engineering/11643/optimization-of-dry-end-milling-process-parameters-of-al-6063-alloy-using-taguchi-method/arun-k-k

call for paper Automotive Engineering, international journal Electrical Engineering, ugc approved journals for engineering


Optimization of Dry End Milling Process Parameters of Al-6063 Alloy Using Taguchi Method IJTSRD


2020 technology trends
2019-TOP-TECHNOLOGIES
2019 papers
2018-TOP-TECHNOLOGIES
2018 papers

IEEE PROJECTS 2020

IEEE PROJECTS
IEEE-PROJECTS-ON-CSE-2020
IEEE-PROJECTS-FOR-EEE-2020
IEEE-PROJECTS-FOR-ECE-2020
IEEE PROJECTS VLSI
EMBEDDED SYSTEM
IEEE PROJECTS ECE
IEEE PROJECTS CSE
ELECTRICAL ENGINEERING
IEEE PROJECTS EEE