Optimization of Turning Process Parameters for EN24 Steel Alloy using Experimental Design IJTSRD


The overarching aim of this work is to optimize the various process parameters involved in turning of EN 24 Steel alloy using Tungsten Carbide inserts to enhance the tool life and surface finish. Appropriate or random selection of cutting parameters have serious effect over the final output responses such as Surface Roughness , Tool life and other related properties of both the work piece and tool . Controlling the effective parameters is the need of the hour in any product manufacturing system. In the present work three different turning process parameters such as Cutting Speed, Feed rate and Depth of cut are considered for optimization study by varying them with three levels. The experimental design matrix for conducting experiments were prepared using Taguchis Orthogonal Array and calculation of Signal to Noise ratio is done for identifying the best combination of parameters. Through ANOVA it is observed that Cutting speed is the most influencing parameter with a maximum contribution of 80.23 comparing to the other input parameters over surface roughness. The S N ratio method Smaller is Better have shown that the parameter level combination A3B1C1 2000m min, 0.05 mm rev, 0.2 mm can provide good surface finish of the material with enhanced tool life.

by C. Shobha | Dr. K. Ganesh Babu | N. Mohammed Raffic “Optimization of Turning Process Parameters for EN24 Steel Alloy using Experimental Design”

Published in International Journal of Trend in Scientific Research and Development (ijtsrd), ISSN: 2456-6470, Volume-3 | Issue-3 , April 2019,

URL: https://www.ijtsrd.com/papers/ijtsrd22911.pdf

Paper URL: https://www.ijtsrd.com/engineering/mechanical-engineering/22911/optimization-of-turning-process-parameters-for-en24-steel-alloy-using-experimental-design/c-shobha

call for paper Aerospace Engineering, international journal Chassis Engineering, ugc approved journals for engineering




Optimization of Turning Process Parameters for EN24 Steel Alloy using Experimental Design IJTSRD IEEE PAPER





2020 technology trends
2019-TOP-TECHNOLOGIES
2019 papers
2018-TOP-TECHNOLOGIES
2018 papers

IEEE PROJECTS 2019


IEEE PROJECTS CSE 2019
IEEE PROJECTS ECE 2019
IEEE PROJECTS EEE 2019
IEEE PROJECTS VLSI
IEEE PROJECTS EMBEDDED SYSTEM

IEEE PROJECTS


IEEE PROJECTS ECE
IEEE PROJECTS CSE COMPUTER SCIENCE
IEEE PROJECTS ELECTRICAL ENGINEERING
IEEE PROJECTS EEE

IEEE PROJECTS