Wireless Mobile Charger Design Based on Inductive Coupling ijtsrd


This research described the construction and implementation of the contactless wireless mobile phone battery charging which becomes popularity nowadays. The power was transferred to the destination by means of inductive coupling between two coils. In transmitter part, the desired frequency was produced from Arduino by means of PWM Pulse Width Modulation . This frequency was used to drive the induction coil by using MOSFET driver. The MOSFET operated as a switch in terms of T on and T off. The power in transmitter coil was transmitted to surroundings by means of electromagnetic field. The receiver coil was induced by electromagnetic field and produces DC voltage. That converted DC voltage was filtered by capacitor and then regulates to required voltage by using voltage regulator. Optimal frequency range for maximum power transfer is gained by performing theatrical approach and experimental test.

by Zaw Min Min Htun | Htay Win Mar “Wireless Mobile Charger Design Based on Inductive Coupling”

Published in International Journal of Trend in Scientific Research and Development (ijtsrd), ISSN: 2456-6470, Volume-3 | Issue-5 , August 2019,

URL: https://www.ijtsrd.com/papers/ijtsrd27882.pdf

Paper URL: https://www.ijtsrd.com/engineering/electronics-and-communication-engineering/27882/wireless-mobile-charger-design-based-on-inductive-coupling/zaw-min-min-htun

call for paper Chassis Engineering, international journal Data Processing, ugc approved journals Structural Engineering




Wireless Mobile Charger Design Based on Inductive Coupling ijtsrd IEEE PAPER





2020 technology trends
2019-TOP-TECHNOLOGIES
2019 papers
2018-TOP-TECHNOLOGIES
2018 papers

IEEE PROJECTS 2019


IEEE PROJECTS CSE 2019
IEEE PROJECTS ECE 2019
IEEE PROJECTS EEE 2019
IEEE PROJECTS VLSI
IEEE PROJECTS EMBEDDED SYSTEM

IEEE PROJECTS


IEEE PROJECTS ECE
IEEE PROJECTS CSE COMPUTER SCIENCE
IEEE PROJECTS ELECTRICAL ENGINEERING
IEEE PROJECTS EEE

IEEE PROJECTS