Optimization of Dry End Milling Process Parameters of Al-6063 Alloy Using Taguchi Method IJTSRD
This paper presents on optimizing the end milling process parameters based on the Taguchi method to minimize surface roughness and Tool wear for the work piece of Al-6063 alloy with high speed steel. The input parameters are speed (rpm), feed rate (mm/min) and depth of cut (mm). S/N ratio is calculated by using Taguchi method […]
Experimental research to Optimize Process Parameters in Machining of Non Conducting Material with hybrid non conconventional machining ijtsrd
Among all non-conventional micro-machining, electrochemical discharge machining (ECDM) is having high quality of material removal rate with zero residual stress. This machining has been accepted as a highly modern technology in micromachining. In this paper an effort has been done on micro drilling of glass using electrochemical discharge machining (ECDM). A fixed tool and a […]
Experimental Research Work to Optimize Process Parameters into Electro Chemical Abrasive Flow Machining using Taguchi Methodology ijtsrd
Electrochemical assisted abrasive flow finishing is a newly developed hybrid finishing process which is used to finish the internal parts of work piece having complicated geometry to large extent. In electrochemical assisted abrasive flow machining higher abrasion of the material was detected due to the combine effect of ECM and AFF processes. In Electrochemical aided […]